Master cylinder question

chuck1 · 06-22-2009, 01:03 PM

Can anyone tell me the size of the ZX14 brake master cylinder stamped on the bottom? Thanks.

**GO 200** · 06-22-2009, 03:49 PM

Quote:

Originally Posted by chuck1

Can anyone tell me the size of the ZX14 brake master cylinder stamped on the bottom? Thanks.

I don't have an answer for you, but someone who does would prolly need to know - front or rear m/c?? Just thinkin' out loud...

chuck1 · 06-22-2009, 08:57 PM

Yeah, I forgot that part. Need to know the size of the front.

hubz14 · 08-10-2009, 07:03 AM

14 Manual does not say, nor gives wear clearances. You need to take yours apart to get that answer.

Ferodo brakes might have bore numbers for you on their website. They need to match up bore wise at both ends, or you have a hard or soft pedal feel if you just toss parts at your mod.

This is a critical move on the brake apply. Good Luck!

chuck1 · 08-10-2009, 07:42 AM

Quote:

Originally Posted by hubz14

14 Manual does not say, nor gives wear clearances. You need to take yours apart to get that answer.

Ferodo brakes might have bore numbers for you on their website. They need to match up bore wise at both ends, or you have a hard or soft pedal feel if you just toss parts at your mod.

This is a critical move on the brake apply. Good Luck!

Actually I was thinking about swapping one onto my 12. The size is cast or stamped into the bottom of the master cylinder body.



06-22-2009, 01:03 PM	#1
chuck1 Senior Member From: whittier, commiefornia Joined: Jun 2003 I Ride: 02 ZX12, 04 ZRX1200 Posts: 982	Master cylinder question Can anyone tell me the size of the ZX14 brake master cylinder stamped on the bottom? Thanks.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



06-22-2009, 08:57 PM	#3
chuck1 Senior Member From: whittier, commiefornia Joined: Jun 2003 I Ride: 02 ZX12, 04 ZRX1200 Posts: 982	Yeah, I forgot that part. Need to know the size of the front.



08-10-2009, 07:03 AM	#4
hubz14 Senior Member From: CA Joined: Feb 2009 Posts: 107 Blog Entries: 4	14 Manual does not say, nor gives wear clearances. You need to take yours apart to get that answer. Ferodo brakes might have bore numbers for you on their website. They need to match up bore wise at both ends, or you have a hard or soft pedal feel if you just toss parts at your mod. This is a critical move on the brake apply. Good Luck!