For those of you using one, What brand is it and how simple was the installation?

i got a hotbodies undercover w/clear taillight and it was a mofo put in..just the taillight(clear alternatives, theres only a few and there all about the same) its easy three screws and switch the plug to the new taillight.

High tech speed.... I got it in a Dutch auction
not too bad to install....

I have an extra you can have in a week. It just an LED taillight though, no turn signals.

Hi have leds tail light with indicators in, and it works very nice. Also the fitting is simple.

I got mine from ebay

This was the best integrated one when I was looking round - easy fit.

Clear Alternatives: Ninja ZX-12R

I heard the LED's go through vibration ?, mine are just the clear lens type with the LED bulbs fitted into the standard bulb holders. Been fine over the last 12 months.

FYI... they might be illegal in your state... In NJ they are illegal.

Clear Alternatives is the way to go good quality i use their led one and i have a mototek undertail for the signals on my 00 zx12r but if price is an issue alot of cheap ones on ebay i see em all the time myself id rather have the quality so i just have to do it once

their lights plug right up to the stock connectors then just bolt it back up that easy

hope that helps!!

heres a pic so u can get a idea what the Clear Alternatives Tailight looks like on my zx12r



BTW i like the signals flashing at a faster speed makes the idiots on the road see me better

Thanks for all the input. I will look into the Clear Alternatives Tailight. I heard Napa has a heavy duty flasher that will regulate the signals. Same with Cycle Gear. Did you guys use a flasher or did your tailight have the resistirs?

I'll put pics of my bike up when I figure it out..

EL12 relay is the way to go no resistors anywhere in my setup besides they get warm to hot and its a PIA to wire in 4 of them they are not small.
all thats needed is the Tridon EL12 relay

another source here from ACE Hardware with part number on link page $8.62 each

Link -----> IMPERIAL 80106-4 TRIDON ELECTRONIC TWO PRONG FLASHER EL12




-------------6. Turn Signal Relay

(((((((((((((((((((((((((((( Load side of relay is usually marked with an X !!! )))))))))))))))))))))))))))))))))))))))))))))))))) )
(((((((((((((((((((((((((((( Orange Wire = Load!! )))))))))))))))))))))))))))))))))))))))))))))))))) )
(((((((((((((((((((((((((((( Brown Yellow stripe Wire connect to prong not marked Load!!!! )))))))))))))))))))))))))))))))))))))))))))))))))) )




You will need to cut the original connector off and solder on 2 spade connectors to plug into new relay
if you cant or don't know how to solder and heat shrink the wires bring the battery tray to someone who does know how to
once done you don't want to have a loose connection IMHO just crimping the connectors on isn't doing the job right
hope this helps everyone thinking about doing this

Awesome! I will go pick one up. All I need now is a manual to figure out where everything is on this bike!

Updated previous post

I see. I guess there is no plug and play flasher.. :) Thanks for the diagram. That will really help!

i have see alot of guys here buy the "PLUG&PAY" ones and they dont seem to work then end up doing it again with an EL12